In plumbing, standard fittings such as compression tube fittings are used for these specific purposes: to seamlessly adapt two or more dissimilar size pipe segments, connect sections of bent or straight tubing and to regulate water flow by using a valve equipped assembly.
Valves can be considered as fittings but are normally referred to as a separate category. Plumbing fittings, just like their pipe material sockets, can be of a plastic or metal material foundation. But a fitting with a movable valve will be normally made of metal, mostly brass.
Building codes are also a determining factor for what fixture and pipe materials will be selected in the building of specific areas of a building. Therefore, taking extreme water temperature, vibration and other pressures inside the assembly environment into consideration will dictate what the suitable pipe and fixture material should be. Get more deatils about Plumbing fittings (also known as ” อุปกรณ์ข้อต่อท่อประปา ” in Thai language ) through http://ecofittingvalve.com/ .
Piping will commonly be made from copper, brass, steel and the plastics CPVC and PVC. The industry standard list of plumbing fittings are Tees, elbows, crosses, caps, barbs, nipples and plugs. These fittings are in all shapes and sizes. A complete description of each part can be obtained online or in standard plumbing guides that are also available online. Apart from this , if you want to know more about Rubber gasket (also known as ” ประเก็นยาง ” in Thai language ) browse http://ecofittingvalve.com/.
One can also find free, information on the internet to direct one on what fittings can be used to follow specific building codes within a specific Geo-targeted location. Other common but more involved plumbing fittings are used for very specific purposes.
For instance, a plumber will install a Clean-out which allows one to easily open and clean out an obstructed drain without the excess work of removing the present pipes fixtures.Clean-Outs are put in strategically easy locations throughout a drainage system inside and outside the building construction.
They generally have screw on top caps that provide the maintenance engineer and easy access to every part of the system. The maintenance worker uses an ‘auger’ or snake to eliminate clogging within the section.
Another frequent fixture, the combo-tee is a bent pipe fixture which permits a plumber to easily remove any obstruction that is clogging the pipe using a snake. The bend is designed specifically to easily accommodate the curved movement of the snake, making cleaning very powerful.
A Coupler is used to join together two pipes of corresponding size. It needs to be obvious that there are lots of different types and can be custom fabricated if needed.
A Union is a threaded coupling used which works just like a huge nut. The threading on both sides allows for easy assembly and dis-assembly of 2 pipes.Soldering is used by heating flux which will permanently join two pipes.PVC piping is permanently combined in a similar manner with solvent welding. This will allow PVC to be joined without heating or melting the plastic piping.